36 6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017
4.5.1 Mounting the 5860
This section of the manual describes mounting the remote annunciator. The annunciator can be flush- or surface-mounted. Figure 4.11
shows the parts of the annunciator. Instructions for disassembling and mounting appear on the following pages.
Figure 4.11 Annunciator Parts
The 5860 comes from the factory fully assembled. You must disassemble it for mounting. To disassemble the annunciator, use a 5/64 hex
wrench to remove the set screws, located on the bottom of the annunciator bezel. (See Figure 4.12 for location of the set screws).
Figure 4.12 Annunciator Back Box and Bezel Details
Set screw location.
Loosen set screws to remove bezel
when disassembling annunciator.
Knockout holes
Holes for surface mounting.
Holes for inserting
wires for flush mounting
(located in all corners).
Stand-off
(throughout)
Screw for placement
of mounting wires
(top and bottom).
To Next Page
Loading...
