6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017 103
8.4.1 Entering / Exiting the Program Menu
To enter Programming Menu:
1. Enter the Installer Code (factory programmed default code is 123456).
2. Then press 7. The menu option displays. See Section 9 for detailed menu information and Section 8.5 for a quick reference listing
all programmable options and JumpStart defaults.
To exit Programming Menu:
When you have completed working with the menus, press left arrow several times until you are exited from programming mode. Two
prompts will display. The first prompt is to make sure you intended to leave the Program Menu (select Yes or No as appropriate). The
second prompt is for accepting all changes. If you select No, any changes you have made since you entered the Program Menu will have
no effect.
Moving through the Menus
Figure 8.7 shows how to move through Program Menu screens, using the System Tests screen as an example.
Figure 8.7 Moving through Program Menu
Selecting Options and Entering Data
There are several ways to make programming selections using the control panel depending on which screen you are currently viewing.
The chart below is a generic explanation.
To Press
Enter the number The corresponding number on the annunciator.
Enter numeric data The appropriate number on the annunciator.
Enter text (alphanumeric data) See Appendix B for complete list of characters.
Select from a scrolling list The up or down arrow to move through the list of available options. When the option
you want to select is displayed, press ENTER.
To Next Page
Loading...
