Honeywell Silent Knight 6820EVS - 2: 5865 Mounting; Configuring SBUS Modules; 1: Assigning SBUS Module Ids

54 6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017
4.12.2 5865 Mounting
Mount the 5865-4 to a standard 4-gang electrical box. Mount the 5865-3 to a standard 3-gang electrical box. In Figure 4.41, the 5865-4
attached to a 4-gang box is used as an example.
Figure 4.41 5865 Mounting Example
The 5865 ships with a set of zone description labels that can be inserted into the 5865 board assembly. These labels can be used in a type-
writer or can be written on by hand. Slide the labels under the plexiglass as shown in Figure 4.42. The LEDs will show through the label
when illuminated.
Figure 4.42 Inserting Zone Description Labels
4.13 Configuring SBUS Modules
This section describes how to configure any system hardware modules that have been added to the system.
4.13.1 Assigning SBUS Module IDs
When installing a hardware module (see Table 4.1 for a list of compatible devices), you must use the DIP switches on the module to
assign an ID# to the module. Address zero is an invalid address and is not allowed.
SILENCE
TROUBLE
RESET
TOP
Zone 1
1st Flr South
Zone 2
1st Flr West
Zone 3
2nd Flr West
Zone 4
2nd Flr East
Zone 5
3rd Floor
Labels can be hand or type written.
Slide label behind plexiglass and
in front of LED board, as shown in
the diagram. LEDs will shine through
label when illuminated.