6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017 49
5. Connect a printer to the 5824 as shown in Figure 4.33.
Figure 4.33 5824 Connection to the Panel
4.10.1 Selecting 5824 Options
Configuring the 5824 includes the following steps:
• Add the module to the system. JumpStart® will add the module automatically (see Section 8.1). You can also add it manually (see
Section 9.2.2).
• Select a name, if desired.
• Select options for the printer and the output port. See below.
Printer and Output Port Options
1. From the Installer Main Menu, select 7 for Program Menu.
2. Select 1 for Module.
3. Select 1 for Edit Module.
4. From the list that displays, select the 5824 module you want to configure.
5. Press the right arrow to skip over the Enter Module ID and Enter Module name options. A screen similar to the one shown in
Figure 4.34 will display.
Figure 4.34 Selecting Printer and Output Port Options
6. Select options for the printer as needed for your installation. Most printers are parallel.
7. If you are using a serial printer, use the next screen to select serial port options as required for your printer. Refer to your printer
manual if you need more
information.
Option Choices
Baud Rate: 75 - 19200
Data Bits: 5 - 8
Stop Bits: .5, 1, 2
Parity: None, Even, Odd
Defaulted to no
Select “Yes” for event logging
Select type of printer
Parallel or Serial
To Next Page
Loading...
