48 6820 / 6820EVS Manual P/N LS10144-001SK-E:C 09/28/2017
4.9.1 6815 Connection to the Panel
Connect the 6815 to the control panel as shown in Figure 4.32. After the 6815 is connected to the panel, it must be added to the system.
This programming step is described in Section 4.13.
Figure 4.32 6815 Connection to Main Panel Assembly
4.10 5824 Serial/Parallel Interface Module Installation
The 5824 serial/parallel interface module allows you to connect a printer to the panel, so you can print a real-time log of system events,
detector status and event history. Instructions for installing the 5824 appear below.
The 5824 and the printer connected to the 5824 Parallel port is ancillary, the serial port can be used for primary fire signaling. The printer
must be a UL 864 listed printer.
5824 installation involves the following steps:
1. Make sure power is off at the panel.
2. Connect the 5824 to the panel as shown in Figure 4.33.
3. Use the DIP switches on the back of the 5824 board to assign an ID# to the 5824 (see Section 4.13.1).
4. Configure the 5824 device through programming. See Section 4.10.1.
NOTE: Four 5824s per panel maximum.
To Next Page
Loading...
