EasyManuals Logo

Honeywell Voyager 1472g User Manual

Honeywell Voyager 1472g
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
86 Voyager XP User Guide
End Character Activation After Good Read
After a barcode is successfully detected and read from the scanner, the aimer can
be programmed either to remain on and scanning, or to turn off. When End Char-
acter Activation After Good Read is enabled, the aimer turns off and stops scan-
ning after a good read. If you scan Do Not End Character Activation After Good
Read, the aimer remains on after a good read. Default = End Character Activation
After Good Read.
Character Activation Timeout
You can set a timeout for the length of time the aimer remains on and attempting
to decode barcodes when using Character Activation Mode. Set the length (in milli-
seconds) for a timeout by scanning the following barcode, then setting the timeout
(from 1-65535 milliseconds) by scanning digits from the Programming Chart,
then scanning Save. Default = 5000 ms.
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scanning,
you can also send a deactivation character to stop scanning. Scan the following On
barcode to use character deactivation, then use Deactivation Character to select
the character you will send from the host to terminate scanning. Default = Off.
Do Not End Character
Activation After Good Read
* End Character Activation
After Good Read
Character Activation Timeout
* Off
On

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Voyager 1472g and is the answer not in the manual?

Honeywell Voyager 1472g Specifications

General IconGeneral
Environmental SealingIP42
Expected Duration of Operation14 hours
Expected Charge Time4.5 hours
Operating Temperature0°C to 50°C (32°F to 122°F)
Storage Temperature-40°C to 70°C (-40°F to 158°F)
IP RatingIP42
Weight210 g (7.4 oz)
ConnectivityBluetooth, USB
Scan PatternArea Image
Decode Capability1D
Battery2400 mAh Li-ion
Drop Specification1.5 m (5 ft) to concrete
Number of Scans50, 000 scans per charge
InterfaceUSB, RS232, Keyboard Wedge, IBM 46xx (RS485)
Humidity5% to 95% relative humidity, non-condensing
Dimensions173 mm x 62 mm x 82 mm (6.8 in x 2.4 in x 3.2 in)
Motion ToleranceUp to 70 cm/s (27.6 in/s) for 13 mil UPC
Scan TechnologyArea Imaging

Related product manuals