Honeywell Voyager 1472g User Manual

CHAPTER
1
Voyager XP User Guide 1
GET STARTED
About This Manual
This User Guide provides installation and programming instructions for the
Voyager XP™ 1470g corded area-imaging scanners and 1472g cordless area-
imaging scanners. Product specifications, dimensions, warranty, and customer
support information are also included.
Note: The selections in this User Guide are dependent on the Voyager XP 147Xg model you
have purchased.
PDF and 2 dimensional barcodes can only be read by model 147Xg2D and cannot be
read by model 147Xg1D.
Honeywell barcode scanners are factory programmed for the most common termi-
nal and communications settings. If you need to change these settings, program-
ming is accomplished by scanning the barcodes in this guide.
An asterisk (*) next to an option indicates the default setting.
Unpack Your Device
After you open the shipping carton containing the product, take the following
steps:
• Check for damage during shipment. Report damage immediately to the carrier
who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.

Honeywell Voyager 1472g Specifications

General

Environmental Sealing	IP42
Expected Duration of Operation	14 hours
Expected Charge Time	4.5 hours
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
IP Rating	IP42
Weight	210 g (7.4 oz)
Connectivity	Bluetooth, USB
Scan Pattern	Area Image
Decode Capability	1D
Battery	2400 mAh Li-ion
Drop Specification	1.5 m (5 ft) to concrete
Number of Scans	50, 000 scans per charge
Interface	USB, RS232, Keyboard Wedge, IBM 46xx (RS485)
Humidity	5% to 95% relative humidity, non-condensing
Dimensions	173 mm x 62 mm x 82 mm (6.8 in x 2.4 in x 3.2 in)
Motion Tolerance	Up to 70 cm/s (27.6 in/s) for 13 mil UPC
Scan Technology	Area Imaging