Honeywell Voyager 1472g User Manual

CHAPTER
3
Voyager XP User Guide 37
CORDLESS SYSTEM OPERATION
Note: This chapter applies only to cordless scanning systems. It does not apply to corded
scanners.
How the Cordless Charge Base/Access Point Works
A cordless charge base or an Access Point provides the link between the cordless
scanner and the host system. The base/Access Point contains an interface assem-
bly and an RF communication module. The RF communication module performs
the data exchange between the cordless scanner and the interface assembly. The
control assembly coordinates the central interface activities including: transmit-
ting/receiving commands and data to/from the host system, performing software
activities (parameter menuing, visual indicator support, power-on diagnostics),
and data translation required for the host system.
The cordless charge base is also a scanner’s battery charger. Refer to Charge
Information, for additional information.
Link the Scanner to a Charge Base
Turn off power before connecting a base, then power up the computer once the
base is fully connected. When the base is connected and powered up, put the scan-
ner in the base to establish a link. The green LED on the base flashes to indicate
the scanner’s battery is charging.

Honeywell Voyager 1472g Specifications

General

Environmental Sealing	IP42
Expected Duration of Operation	14 hours
Expected Charge Time	4.5 hours
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
IP Rating	IP42
Weight	210 g (7.4 oz)
Connectivity	Bluetooth, USB
Scan Pattern	Area Image
Decode Capability	1D
Battery	2400 mAh Li-ion
Drop Specification	1.5 m (5 ft) to concrete
Number of Scans	50, 000 scans per charge
Interface	USB, RS232, Keyboard Wedge, IBM 46xx (RS485)
Humidity	5% to 95% relative humidity, non-condensing
Dimensions	173 mm x 62 mm x 82 mm (6.8 in x 2.4 in x 3.2 in)
Motion Tolerance	Up to 70 cm/s (27.6 in/s) for 13 mil UPC
Scan Technology	Area Imaging