EasyManuals Logo

Honeywell Voyager 1472g User Manual

Honeywell Voyager 1472g
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #192 background imageLoading...
Page #192 background image
Voyager XP User Guide 175
The scanner scans until a barcode has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see "Read Time-Out" on page 4-
79 for a description, and the serial command on page 184).
Reset the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults barcode below. This resets the scanner to the custom default
settings. If there are no custom defaults, it will reset the scanner to the factory
default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
Note: If using a cordless system, scanning this barcode also causes both the scanner and
the base or Access Point to perform a reset and become unlinked. The scanner must
be placed in its base to re-establish the link. If using an Access Point, the linking
barcode must be scanned. See Cordless System Operation beginning on page 37 for
additional information.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
Menu Commands
Activate Custom Defaults
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page
Product Default Settings
Set Custom Defaults Set Custom Defaults MNUCDP 8
Save Custom Defaults MNUCDS 8
Reset the Custom Defaults Activate Custom Defaults DEFALT 9
Program the Interface
Plug and Play Codes Keyboard Wedge:
IBM PC AT and Compatibles with CR
suffix
PAP_AT 11
Laptop Direct Connect with CR suffix PAPLTD 12
RS232 Serial Port PAP232 12
Plug and Play Codes:
RS485
IBM Port 5B Interface PAPP5B 12
IBM Port 9B HHBCR-1 Interface PAP9B1 12
IBM Port 17 Interface PAPP17 13

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Voyager 1472g and is the answer not in the manual?

Honeywell Voyager 1472g Specifications

General IconGeneral
Environmental SealingIP42
Expected Duration of Operation14 hours
Expected Charge Time4.5 hours
Operating Temperature0°C to 50°C (32°F to 122°F)
Storage Temperature-40°C to 70°C (-40°F to 158°F)
IP RatingIP42
Weight210 g (7.4 oz)
ConnectivityBluetooth, USB
Scan PatternArea Image
Decode Capability1D
Battery2400 mAh Li-ion
Drop Specification1.5 m (5 ft) to concrete
Number of Scans50, 000 scans per charge
InterfaceUSB, RS232, Keyboard Wedge, IBM 46xx (RS485)
Humidity5% to 95% relative humidity, non-condensing
Dimensions173 mm x 62 mm x 82 mm (6.8 in x 2.4 in x 3.2 in)
Motion ToleranceUp to 70 cm/s (27.6 in/s) for 13 mil UPC
Scan TechnologyArea Imaging

Related product manuals