Honeywell Vuquest 3310g - Wincor Nixdorf Terminal Default Settings

2 - 7
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on page 1-5 first, then scan the
programming code above.
Wincor Nixdorf Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor
Nixdorf terminal. This bar code sets the baud rate to 9600 bps and the
data format to 8 data bits, no parity, 1 stop bit.
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on page 1-5 first, then scan the
programming code above.
NCR Bioptic Settings
Wincor Nixdorf Terminal Settings