3 - 16
Use shorter delays in applications where repetitive bar code scanning is
required. Reread Delay only works when in a Presentation Mode (see page 3-
7). Default = Medium.
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-65,535 milliseconds) by scanning digits from the
inside back cover, then scanning Save.
2D Reread Delay
Sometimes 2D bar codes can take longer to read than other bar codes. If you
wish to set a separate Reread Delay for 2D bar codes, scan one of the program-
ming codes that follows. 2D Reread Delay Off indicates that the time set for
Reread Delay is used for both 1D and 2D bar codes. Default = 2D Reread Delay
Off.
Short (500 ms)
* Medium (750 ms)
Long (1000 ms)
Extra Long (2000 ms)
User-Specified Reread Delay
To Next Page
Loading...
