2 - 8
Wincor Nixdorf Beetle™ Terminal
Default Settings
Scan the following Plug and Play code to program the scanner for a Wincor
Nixdorf Beetle terminal. Communication using 115200bps, no parity bit, 8
data bits and 1 stop bit. The following prefixes are programmed for each
symbology:
Note: If you are having unexpected results with this programming code,
scan the Activate Defaults bar code on page 1-5 first, then scan the
programming code above.
Symbology Prefix Symbology Prefix
Code 128 K EAN-13 A
Code 93 L GS1-128 P
Codabar N Interleaved 2 of 5 I
UPC-A A0 Straight 2 of 5 IATA H
UPC-E C All other bar codes M
EAN-8 B
Wincor Nixdorf Beetle Settings
To Next Page
Loading...
