Honeywell Vuquest 3310g - Intercharacter, Interfunction, and Intermessage Delays; Intercharacter Delay

4 - 5
Scan the following bar code to set the communication check character type.
Default = None.
Intercharacter, Interfunction, and
Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly.
Intercharacter, interfunction, and intermessage delays slow the transmission of
data, increasing data integrity.
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may
be placed between the transmission of each character of scanned data.
Scan the Intercharacter Delay bar code below, then scan the number of
5ms delays, and the Save bar code using the Programming Chart inside
the back cover of this manual.
* None
LRC Starts on 1st Character
LRC Starts on 2nd Character
CRC
1 2345
Intercharacter Delay
Prefix Scanned Data Suffix
Intercharacter Delay