3 - 12
Streaming Presentation™ Mode
When in Streaming Presentation mode, the scanner’s aimer goes out after a
short time, but the scan illumination remains on all the time to continuously
search for bar codes. Two modes are available, Normal and Enhanced. Nor-
mal mode offers good scan speed and the longest working ranges (depth of
field). Enhanced mode will give you the highest possible scan speed but
slightly less range than Normal mode. Enhanced mode is best used when you
require a very fast scan speed and don’t require a long working range.
When using Preferred Symbology (page 3-21), a lower priority symbol must be
centered on the aiming pattern to be read in Streaming Presentation Mode.
Mobile Phone Read Mode
When this mode is selected, your scanner is optimized to read bar codes from
mobile phone or other LED displays. However, the speed of scanning printed
bar codes may be slightly lower when this mode is enabled. You can enable
Mobile Phone Reading for either a hand held device, or for a hands-free (pre-
sentation) application.
Note: To turn off Mobile Phone Read Mode, scan a Manual or Serial Trigger
Mode bar code (see page 3-5).
Hands-Free Time-Out
The Presentation Mode is referred to as “hands-free” mode. If the scanner’s
button is pressed when using a hands-free mode, the scanner changes to man-
ual trigger mode. You can set the time the scanner should remain in manual
Streaming Presentation Mode
- Normal
Streaming Presentation Mode
- Enhanced
Hand Held Scanning - Mobile
Phone
Streaming Presentation -
Mobile Phone
To Next Page
Loading...
