Honeywell Vuquest 3310g - LED Illumination - Manual Trigger; Serial Trigger Mode

3 - 6
less range than Normal mode. Enhanced mode is best used when you require
a very fast scan speed and don’t require a long working range. Default = Man-
ual Trigger-Normal.
LED Illumination - Manual Trigger
If you wish to set the illumination LED brightness, scan one of the bar
codes below. This sets the LED illumination for the scanner when the but-
ton is pressed. Default = High.
Note: The LEDs are like a flash on a camera. The lower the ambient light
in the room, the brighter the LEDs need to be so the scanner can
“see” the bar codes.
Serial Trigger Mode
You can activate the scanner either by pressing the button, or using a serial trig-
ger command (see Trigger Commands on page 11-4). When in serial mode,
the scanner scans until a bar code has been read or until the deactivate com-
* Manual Trigger - Normal
Manual Trigger - Enhanced
Off
Low
Medium
* High