EasyManuals Logo

Honeywell Vuquest 3310g User Manual

Honeywell Vuquest 3310g
278 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
3 - 14
Character Activation Laser Timeout
You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when using Character Activation Mode.
Set the length (in milliseconds) for a timeout by scanning the following bar
code, then setting the timeout (from 1-65535 milliseconds) by scanning dig-
its from the Programming Chart, then scanning Save. Default = 5000 ms.
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the fol-
lowing On bar code to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to termi-
nate scanning. Default = Off.
End Character Activation After Good Read
After a bar code is successfully detected and read from the scanner, the
illumination can be programmed either to remain on and scanning, or to
turn off. When End Character Activation After Good Read is enabled,
the illumination turns off and stops scanning after a good read. If you scan
Do Not End Character Activation After Good Read, the illumination
remains on after a good read. Default = End Character Activation After
Good Read.
Character Activation Laser
Timeout
* Off
On

Table of Contents

Other manuals for Honeywell Vuquest 3310g

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Vuquest 3310g and is the answer not in the manual?

Honeywell Vuquest 3310g Specifications

General IconGeneral
TypeFixed bar code reader
Sensor type-
Yaw reading angle-65 - 65 °
Pitch reading angle-45 - 45 °
Optical sensor resolution838 pixels
Light levels (direct sunlight)0 - 100000 lx
Standard interfacesPS/2
Connectivity technologyWired
Input voltage5 V
Power consumption450 mA
Power source typeAC
Power consumption (standby)0.45 W
Power consumption (typical)2.3 W
Product colorWhite
International Protection (IP) codeIP53
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)0 - 95 %
Cables includedUSB
Weight and Dimensions IconWeight and Dimensions
Depth74 mm
Width50 mm
Height26 mm
Weight75 g

Related product manuals