3 - 27
When the output sequence is Off, the bar code data is output to the host as
the scanner decodes it. Default = Off.
Note: This selection is unavailable when the Multiple Symbols Selection is
turned on.
Multiple Symbols
When this programming selection is turned On, it allows you to read multiple
symbols with a single press of the scanner’s button. If you press and hold the
button, aiming the scanner at a series of symbols, it reads unique symbols
once, beeping (if turned on) for each read. The scanner attempts to find and
decode new symbols as long as the button is pressed. When this programming
selection is turned Off, the scanner will only read the symbol closest to the aim-
ing beam. Default = Off.
Required
On/Not Required
*Off
To Next Page
Loading...
