Care and maintenance
Inappropriate care and maintenance puts the
operational safety of the machine at risk. This
can lead to accidents with severe or even fatal
physical injuries.
¾ Conform with prescribed schedules for repeti-
tive tests or inspections.
¾ Service the machine according to the
maintenance plan, see chapter “Care and
maintenance”.
¾ Only perform the work described in these
operating instructions.
¾ Before starting maintenance and service work
park the machine on level and rm ground and
secure it against rolling away.
¾ De-pressurise the hydraulic system and lower
or support the implement.
¾ Prior to working on the electrical system,
disconnect it from the electric power supply.
¾ Before cleaning the machine with high pres-
sure cleaning equipment cover all openings,
which should stay clear of water, steam or
cleaning agents for reasons of safety or
operation. Do not aim the water jet directly
on electric or electronic components and
bearings.
¾ When cleaning with high pressure or steam
cleaning equipment keep a distance of at least
50 cm to machine components.
¾ After cleaning, check all hydraulic lines for
leaks and loose connections.
¾ Check for chang and signs of other damage.
Remedy any faults immediately!
¾ Screw connections loosened for the purpose
of maintenance and service work must be
retighten after work is completed.
¾ All other maintenance and repair tasks,
which are not described in the operating
instructions, must only be carried out by
an authorized professional workshop or
by an operator who has been trained by
HORSCH for this purpose.
Do not clean new machines with a steam jet
of a high pressure cleaner. The paint takes
approx. 3 months to cure and could thus be
damaged if this time has not yet expired.
13
To Next Page
