To Next Page

To Previous Page

100 Kilo Sliding Shelf kit 16

Secure the opposite end of the cable management arm to the rack using two M6 x 12 pan HD screws

and M6 external washers.

Installation is complete.

Using the 100 Kilo Sliding Shelf

Use the handle on the front of the sliding shelf to slide it in and out of the rack. When sliding the shelf back

into the rack, there may be resistance. Apply pressure as needed to fully move the shelf into the rack.

IMPORTANT:

Be sure to secure all rack mount system components when moving the shelf out of

the rack.

Other manuals for HP 10000 G2 Series

Questions and Answers:

Need help?

Do you have a question about the HP 10000 G2 Series and is the answer not in the manual?

General