HP 10000 G2 Series - Side Mount; Installing the Cross-Over Bracket

Cable Management Bracket kit 32
3.
Using a T-25 Torx driver, insert one M6 x 16-mm Torx screw to secure the cable management D-ring
bracket to the rack (2).
Side mount
1. Align the cable management D-ring bracket with the screw hole in the desired location on the side of
your rack (1).
2. Using a T-25 Torx driver, insert one M5.5 x10-mm Torx screw to secure the cable management D-ring
bracket to the rack (2).
Installing the cross-over bracket
1. Align the cross-over bracket with the appropriate screw holes in the desired location across the back of
the rack (1).