Mini Stabilizer kit 83
Mini Stabilizer kit
About this device
The HP Mini Stabilizer kit provides stability and support and prevents possible tipping when you install,
remove, or access equipment within the rack.
Kit contents
Item Quantity
600-mm (23.62-in) Front stabilizer
mount
—or—
800-mm (31.50-in) Front stabilizer
mount
1
1
Stabilizer feet
2
M8 x 20-mm bolt
8
M8 flat washer
8
This kit might contain extra hardware for your convenience.
Required tools
The following tools are required for installation:
• Ratchet with sockets
• Adjustable wrench
Installing the stabilizer
NOTE: HP recommends using the side feet, provided with this kit, to stabilize stand-alone racks
from the side. If you are stabilizing racks that are secured together with baying kits, the side feet
are optional on either end of the row.
1. Align the front foot with the front caster plate.
To Next Page
Loading...
Need help?
General
