Rack Air Duct kit 98
b.
Using a T-30 Torx driver, insert and tighten one M6 flathead screw to secure each hinge bracket to
the rear extension assembly (2).
3. Lift the rear doors, aligning them with the hinge brackets on the rear extension assembly (1).
4. Push down the hinge pins, and then insert the hinge into the holes on the rear door (2).
Assembling the kits
1. Assemble the lower duct.
a. Align the hooks of the side panels with the slots of the front and back panels (1).
b. Slide the six hooks into the slots, and then slide the panel down until it locks in place (2).
To Next Page
Loading...
