HP 5820X Series

109
To do… Use the command… Remarks
2. Enter VLAN view
vlan vlan-id
Required.
If the specified VLAN does not exist, this
command creates the VLAN first.
3. Assign one or a group of
access ports to the current
VLAN
port interface-list
Required.
By default, all ports belong to VLAN 1.
To assign an access port (in interface view) or multiple access ports (in port group view) to a VLAN:
To do… Use the command… Remarks
1. Enter system view
system-view —
Enter Ethernet
interface view
interface interface-type
interface-number
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
2. Enter interface
view
(including
Ethernet
interface view,
Layer 2
aggregate
interface view)
or port group
view
Enter port
group view
port-group manual port-group-
name
Required.
Use either command.
• In Ethernet interface view, the
subsequent configurations
apply to the current port.
• In port group view, the
subsequent configurations
apply to all ports in the port
group.
• In Layer 2 aggregate interface
view, the subsequent
configurations apply to the
Layer 2 aggregate interface
and all its member ports.
3. Configure the link type of the
port or ports as access
port link-type access
Optional.
The link type of a port is access
by default.
4. Assign the current access ports to
a VLAN
port access vlan vlan-id
Optional.
By default, all access ports
belong to VLAN 1.
Before assigning an access port to a VLAN, create the VLAN first.
In VLAN view, only Layer 2 Ethernet interfaces can be assigned to the current VLAN.
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it fails
to do that on an aggregation member port, it skips the port and moves to the next port.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. Assign it to a VLAN in interface view (including Ethernet interface
view, Layer 2 aggregate interface view) or port group view.
To assign a trunk port to one or multiple VLANs: