HP 5820X Series

125
To do… Use the command… Remarks
Enter Ethernet
interface view
interface interface-type
interface-number
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
5. Enter
interface
view or port
group view
Enter port group
view
port-group manual port-group-
name
Required.
Use either command.
• In Ethernet interface view,
the subsequent
configurations apply to the
current port.
• In port group view, the
subsequent configurations
apply to all ports in the port
group.
• In Layer 2 aggregate
interface view, the
subsequent configurations
apply to the Layer 2
aggregate interface and all
its member ports.
6. Configure port link type as hybrid
port link-type hybrid Required.
7. Configure the hybrid ports to
permit the specified IP subnet-
based VLANs to pass through
port hybrid vlan vlan-id-list
{ tagged | untagged }
Required.
8. Associate the hybrid ports with the
specified IP subnet-based VLAN
port hybrid ip-subnet-vlan vlan
vlan-id
Required.
After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it fails
to do that on an aggregation member port, it skips the port and moves to the next port.
Displaying and maintaining VLAN
To do... Use the command… Remarks
Display VLAN information
display vlan [ vlan-id1 [ to vlan-id2 ] | all |
dynamic | reserved | static ] [ | { begin |
exclude | include } regular-expression ]
Available in any view
Display VLAN interface
information
display interface vlan-interface [ vlan-
interface-id ] [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display hybrid ports or trunk ports
on the device
display port { hybrid | trunk } [ | { begin |
exclude | include } regular-expression ]
Available in any view
Display MAC address-to-VLAN
entries
display mac-vlan { all | dynamic | mac-
address mac-address [ mask mac-mask ] |
static | vlan vlan-id } [ | { begin | exclude |
include } regular-expression ]
Available in any view
Display all interfaces with MAC-
based VLAN enabled
display mac-vlan interface [ | { begin |
exclude | include } regular-expression ]
Available in any view