HP 5820X Series

45
• When the minimum threshold is reached, the eligible member ports change to the selected state,
and the link of the aggregate interface goes up.
To set the minimum number of selected ports for an aggregation group:
To do... Use the command... Remarks
1. Enter system view
system-view —
2. Enter Layer 2 aggregate
interface view
interface bridge-aggregation
interface-number
—
3. Set the minimum number of
selected ports for the
aggregation group
link-aggregation selected-port
minimum number
Required
Not specified by default
Shutting down an aggregate interface
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group in the following ways:
• When an aggregate interface is shut down, all selected ports in the aggregation group become
unselected and their link state becomes down.
• When an aggregate interface is brought up, the aggregation state of ports in the aggregation
group is recalculated and their link state becomes up.
To shut down an aggregate interface:
To do... Use the command... Remarks
1. Enter system view
system-view —
2. Enter Layer 2 aggregate
interface view
interface bridge-aggregation
interface-number
—
3. Shut down the aggregate
interface
shutdown
Required.
By default, aggregate
interfaces are up.
Restoring the default settings for an aggregate interface
To restore the default settings for an aggregate interface:
To do... Use the command... Remarks
1. Enter system view
system-view —
2. Enter aggregate interface view
interface bridge-aggregation
interface-number
—
3. Restore the default settings for
the aggregate interface
default Required
Configuring load sharing for link aggregation
groups