HP 5820X Series

46
CAUTION:
By default, an aggregation group uses the global link-aggregation load sharing criterion or criteria.
Configure the group-specific link-a
gg
re
g
ation load sharin
g
criteria to overwrite the
g
lobal ones, except
those specified with the destination-port, source-port, or ingress-port keywords.
Determine how traffic is load-shared across a link aggregation group by configuring load sharing criteria.
The criteria can be service port numbers, IP addresses, MAC addresses, receiving ports, or any
combination.
The switch supports configuring global and group-specific aggregation load sharing criteria. A link
aggregation group preferentially uses group-specific load sharing criteria. If no group-specific load
sharing criteria is available, the group uses the global load sharing criteria.
Configuring the global link-aggregation load sharing criteria
To configure global link-aggregation load sharing criteria:
To do... Use the command... Remarks
1. Enter system view
system-view —
2. Configure the global link-
aggregation load
sharing criteria
link-aggregation load-sharing mode
{ destination-ip | destination-mac |
destination-port | ingress-port |
source-ip | source-mac | source-port }
*
Required.
The default global aggregation
load sharing criteria are ingress
port, source MAC address and
destination MAC address for
Layer 2 packet types, such as
ARP, and source and destination
IP addresses for Layer 3 packet
types, such as IP packet
Set the following global aggregation load sharing criteria:
• Source IP address
• Destination IP address
• Source MAC address
• Destination MAC address
• Source IP address and destination IP address
• Source IP address and source port number
• Destination IP address and destination port number
• Any two or all three of these elements – ingress port number, source MAC address, and destination
MAC address
Configuring group-specific load sharing criteria
To configure load sharing criteria for a link aggregation group:
To do… Use the command… Remarks
1. Enter system view
system-view —
2. Enter aggregate
interface view
interface bridge-aggregation
interface-number
—