HP 5820X Series

134
Step
Command Remarks
9. Configure the uplink port
for the isolate-user-VLAN.
Enter Layer 2 Ethernet or aggregate
interface view:
interface interface-type interface-
number
Or
interface bridge-aggregation
interface-number
Configure the port to operate in
promiscuous mode in a specific
VLAN:
port isolate-user-vlan vlan-id
promiscuous
By default, a port does not
operate in promiscuous mode or
host mode in a VLAN.
10. Return to system view.
quit N/A
11. Configure a downlink port
for the isolate-user-VLAN.
Enter Layer 2 Ethernet or aggregate
interface view:
interface interface-type interface-
number
Or
interface bridge-aggregation
interface-number
Configure the link type of the port:
port link-type { access | hybrid |
trunk }
Assign the downlink port to the
secondary VLAN according to its link
type:
port access vlan vlan-id
Or
port hybrid vlan vlan-list { tagged |
untagged }
Or
port trunk permit vlan { vlan-list |
all }
Configure the port to operate in host
mode:
port isolate-user-vlan host
By default, a port does not
operate in host mode or
promiscuous mode.
12. Return to system view.
quit N/A
Displaying and maintaining isolate-user-VLAN
To do... Use the command... Remarks
Display the mapping between an
isolate-user-VLAN and its secondary
VLANs and information about these
VLANs
display isolate-user-vlan [ isolate-user-
vlan-id ] [ | { begin | exclude |
include } regular-expression ]
Available in any view