HP 5820X Series

153
GVRP configuration task list
Complete these tasks to configure GVRP:
Task Remarks
Configuring GVRP functions Required
Configuring GARP timers Optional
GVRP configuration made in Ethernet interface view or Layer 2 aggregate interface view takes effect on
the current interface only. GVRP configuration made in port group view takes effect on all member ports
in the group.
GVRP configuration made on a member port in an aggregation group takes effect only after the port is
removed from the aggregation group.
Configuring GVRP functions
Before enabling GVRP on a port, you must enable GVRP globally. In addition, GVRP can be configured
only on trunk ports, and you must assign the involved trunk ports to all dynamic VLANs.
To configure GVRP functions on a trunk port:
To do… Use the command… Remarks
1. Enter system view
system-view ––
2. Enable GVRP globally
gvrp
Required.
Globally disabled by
default.
Enter Ethernet interface
view or Layer 2
aggregate interface view
interface interface-type interface-
number
3. Enter
Ethernet
interface
view, Layer
2 aggregate
interface
view, or
port-group
view
Enter port-group view
port-group manual port-group-
name
Required.
Perform either of the
commands.
4. Configure the link type of the ports as
trunk
port link-type trunk
Required.
Access by default.
5. Assign the trunk ports to all VLANs
port trunk permit vlan all
Required.
By default, a trunk port
is assigned to VLAN 1
only.
6. Enable GVRP on the ports
gvrp
Required.
Disabled by default.