EasyManua.ls Logo

HP 5820X Series

HP 5820X Series
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
128
To do… Use the command… Remarks
3. Configure the VLAN as a
super VLAN
supervlan Required.
4. Associate the super VLAN
with the specified sub-VLANs
subvlan vlan-list
Required.
VLANs specified by vlan-list must be
the sub-VLANs configured earlier.
Configure a VLAN interface for the super VLAN
To configure a VLAN interface for the super VLAN:
To do… Use the command… Remarks
1. Enter system view
system-view
2. Create a VLAN interface, and
enter VLAN interface view
interface vlan-interface vlan-
interface-id
Required.
The value of vlan-interface-id must
be the ID of the super VLAN.
ip address ip-address { mask |
mask-length } [ sub ]
3. Configure the IP address of
the VLAN interface
ipv6 address { ipv6-address
{ prefix-length | link-local } |
ipv6-address/prefix-length
[ anycast | eui-64 ] | auto [ link-
local ] }
Required.
Use either command.
By default, the IP address of a
VLAN interface is not configured.
Enable local
proxy ARP
local-proxy-arp enable
4. Enable
local proxy
ARP
Enable local
proxy ND
local-proxy-nd enable
Required.
Use either command.
Disabled by default.
Configure the IP address of the VLAN interface with that of the corresponding super VLAN.
For more information about the local-proxy-arp enable command and the local proxy ARP function, see
the Layer 3—IP Services Configuration Guide.
You cannot configure a super VLAN as the guest VLAN for a port, and vice versa. For more information
about guest VLAN, see the Security Configuration Guide.
Configure Layer 2 multicast for a super VLAN. However, the configuration cannot take effect.
Configure DHCP, DHCPv6, Layer 3 multicast, and dynamic routing for the VLAN interface of a super
VLAN. However, only DHCP and DHCPv6 take effect.
Configuring VRRP for the VLAN interface of a super VLAN affects network performance. HP does not
recommend you to configure this function
Displaying and maintaining super VLAN
To do… Use the command… Remarks
Display the mapping between a super
VLAN and its sub-VLANs
display supervlan [ supervlan-id ] [ |
{ begin | exclude | include } regular-
expression ]
Available in any view

Table of Contents

Related product manuals