HP 5820X Series

10
To do… Use the command… Remarks
2. Enter Ethernet interface view
interface interface-type interface-
number
—
3. Enable link-up port auto
power-down
eee enable
Required
Disabled by default
This feature is only available on the HP 5800AF-48G Switch (JG225A).
When you configure the eee enable command on a link-up port, the port automatically goes down and
up.
Configuring a Layer 2 Ethernet interface
Layer 2 Ethernet interface configuration task list
Complete these tasks to configure an Ethernet interface operating in bridge mode:
Task Remarks
Configuring a port group Optional
Enabling link-down port auto power-down Optional
Setting speed options for auto negotiation on an Ethernet interface Optional
Configuring traffic storm protection Optional
Enabling single-port loopback detection on an Ethernet interface Optional
Enabling multi-port loopback detection Optional
Setting the MDI mode of an Ethernet interface Optional
Enabling bridging on an Ethernet interface Optional
Testing the cable connection of an Ethernet interface Optional
Configuring the connection mode of an Ethernet interface Optional
Configuring a port group
Some interfaces on your switch may use the same set of settings. To configure these interfaces in bulk
rather than one by one, you can assign them to a port group.
You create port groups manually. All settings made for a port group apply to all member ports of the
group. For example, you can configure a traffic suppression threshold (see "Configuring traffic storm
pr
otection") for multiple interfaces in bulk by assigning these interfaces to a port group.
Even though the settings are made on the port group, they are saved on an interface basis rather than on
a port group basis. You can only view the settings in the view of each interface by use the display
current-configuration or display this command.
To configure a port group:
To do… Use the command… Remarks
1. Enter system view
system-view —