HP 5820X Series

174
1.
Configure PE 1:
{ Configure GigabitEthernet 1/0/1:
# Configure GigabitEthernet 1/0/1 as a hybrid port to permit frames of VLAN 100 and VLAN
200 to pass through untagged.
<PE1> system-view
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] port link-type hybrid
[PE1-GigabitEthernet1/0/1] port hybrid vlan 100 200 untagged
[PE1-GigabitEthernet1/0/1] quit
# Create class A10 and configure the class to match frames with CVLAN 10.
[PE1] traffic classifier A10
[PE1-classifier-A10] if-match customer-vlan-id 10
[PE1-classifier-A10] quit
# Create traffic behavior P100 and add the action of inserting outer VLAN tag 100.
[PE1] traffic behavior P100
[PE1-behavior-P100] nest top-most vlan-id 100
[PE1-behavior-P100] quit
# Create class A20 and configure the class to match frames with CVLAN 20. Create traffic
behavior P200 and add the action of inserting outer VLAN tag 200.
[PE1] traffic classifier A20
[PE1-classifier-A20] if-match customer-vlan-id 20
[PE1-classifier-A20] quit
[PE1] traffic behavior P200
[PE1-behavior-P200] nest top-most vlan-id 200
[PE1-behavior-P200] quit
# Create a QoS policy named qinq, associate traffic class A10 with traffic behavior P100, and
associate traffic class A20 with traffic behavior P200.
[PE1] qos policy qinq
[PE1-qospolicy-qinq] classifier A10 behavior P100
[PE1-qospolicy-qinq] classifier A20 behavior P200
[PE1-qospolicy-qinq] quit
# Enable basic QinQ on the port.
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] qinq enable
# Apply QoS policy qinq to the incoming traffic on the port.
[PE1-GigabitEthernet1/0/1] qos apply policy qinq inbound
{ Configure GigabitEthernet 1/0/2:
# Configure GigabitEthernet 1/0/2 as a trunk port and assign it to VLAN 100 and VLAN 200.
[PE1] interface gigabitethernet 1/0/2
[PE1-GigabitEthernet1/0/2] port link-type trunk
[PE1-GigabitEthernet1/0/2] port trunk permit vlan 100 200
# Create class A100 and configure the class to match frames with CVLAN 10 and SVLAN 100.
[PE1] traffic classifier A100
[PE1-classifier-A100] if-match customer-vlan-id 10
[PE1-classifier-A100] if-match service-vlan-id 100
[PE1-classifier-A100] quit