EasyManua.ls Logo

HP 5820X Series

HP 5820X Series
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
198
# Set port GigabitEthernet 1/0/2 as a trunk port, and assign it to VLAN 100.
[PE2] interface gigabitethernet 1/0/2
[PE2-GigabitEthernet1/0/2] port link-type trunk
[PE2-GigabitEthernet1/0/2] port trunk permit vlan 100
3. Configuring PE 3
# Configure an uplink policy down_uplink for customer-side port GigabitEthernet 1/0/1 to substitute
SVLAN ID 200 for the SVLAN ID in the incoming traffic tagged with CVLAN 10 and SVLAN 100.
<PE3> system-view
[PE3] traffic classifier down_uplink
[PE3-classifier-down_uplink] if-match customer-vlan-id 10
[PE3-classifier-down_uplink] if-match service-vlan-id 100
[PE3-classifier-down_uplink] quit
[PE3] traffic behavior down_uplink
[PE3-behavior-down_uplink] remark service-vlan-id 200
[PE3-behavior-down_uplink] quit
[PE3] qos policy down_uplink
[PE3-qospolicy-down_uplink] classifier down_uplink behavior down_uplink
[PE3-qospolicy-down_uplink] quit
# Configure a downlink policy down_downlink for customer-side port GigabitEthernet 1/0/1 to substitute
CVLAN 10 and SVLAN 100 for traffic tagged with CVLAN 30 and SVLAN 200.
[PE3] traffic classifier down_downlink
[PE3-classifier-down_downlink] if-match customer-vlan-id 30
[PE3-classifier-down_downlink] if-match service-vlan-id 200
[PE3-classifier-down_downlink] quit
[PE3] traffic behavior down_downlink
[PE3-behavior-down_downlink] remark customer-vlan-id 10
[PE3-behavior-down_downlink] remark service-vlan-id 100
[PE3-behavior-down_downlink] quit
[PE3] qos policy down_downlink
[PE3-qospolicy-down_downlink] classifier down_downlink behavior down_downlink
[PE3-qospolicy-down_downlink] quit
# Configure an uplink policy up_uplink for network-side port GigabitEthernet 1/0/2 to substitute CVLAN
30 for the CVLAN ID of the outgoing traffic tagged with CVLAN 10 and SVLAN 200.
[PE3] traffic classifier up_uplink
[PE3-classifier-up_uplink] if-match customer-vlan-id 10
[PE3-classifier-up_uplink] if-match service-vlan-id 200
[PE3-classifier-up_uplink] quit
[PE3] traffic behavior up_uplink
[PE3-behavior-up_uplink] remark customer-vlan-id 30
[PE3-behavior-up_uplink] quit
[PE3] qos policy up_uplink
[PE3-qospolicy-up_uplink] classifier up_uplink behavior up_uplink
[PE3-qospolicy-up_uplink] quit
# Set customer-side port GigabitEthernet 1/0/1 as a trunk port, assign it to VLAN 200, and apply uplink
policy down_uplink to the incoming traffic and downlink policy down_downlink to the outgoing traffic on
the port.
[PE3] interface gigabitethernet 1/0/1

Table of Contents

Related product manuals