224
5.
Verify the configuration
Through the specific menu on the DC server, you can see the data exchange procedure between the DC
server and Switch A to verify the configuration. Take a Qlogic adapter on the DC server for example. The
data exchange procedure is:
Wed Aug 25 15:08:56 CST 2010
DCBX TLV (Type-Length-Value) Data
=================================
DCBX Parameter Type and Length
DCBX Parameter Length: 13
DCBX Parameter Type: 2
DCBX Parameter Information
Parameter Type: Current
Pad Byte Present: Yes
DCBX Parameter Valid: Yes
Reserved: 0
DCBX Parameter Data
Priority Group ID of Priority 1: 0
Priority Group ID of Priority 0: 2
Priority Group ID of Priority 3: 3
Priority Group ID of Priority 2: 1
Priority Group ID of Priority 5: 5
Priority Group ID of Priority 4: 4
Priority Group ID of Priority 7: 7
Priority Group ID of Priority 6: 6
Priority Group 0 Percentage: 1
Priority Group 1 Percentage: 3
Priority Group 2 Percentage: 5
Priority Group 3 Percentage: 24
// This value is calculated by the Qlogic adapter according to the local precedence, and is different
from the configured weight value.
Priority Group 4 Percentage: 8
Priority Group 5 Percentage: 14
Priority Group 6 Percentage: 21
Priority Group 7 Percentage: 24
Number of Traffic Classes Supported: 8
DCBX Parameter Information
Parameter Type: Remote
Pad Byte Present: Yes
To Next Page
Loading...
