HP 8168E - Page 101

5
:STATus:OPERation:ENABle
Syntax :STATus:OPERation:ENABle < wsp >< value >
Description This command sets the bits in the ENABle register that
enable the contents of the EVENt register to aect the Status
Byte (STB). Setting a bit in this register to 1 enables the
corresponding bit in the EVENt register to aect bit 7 of the
Status Byte.
:STATus:OPERation:ENABle?
Syntax :STATus:OPERation:ENABle?
Description This query returns the current contents of the
OPERation:ENABle register.
Example OUTPUT 724;":STAT:OPER:ENAB 768"
OUTPUT 724;":STAT:OPER:ENAB?"
ENTER 724;A$
:STATus:OPERation[:EVENt]?
Syntax :STATus:OPERation [ :EVENt ] ?
Description This query reads the contents of the OPERation:EVENt register.
Only two bits of the event register are used (whether these
bits contain information depends on the transition register
conguration):
Bit 8, which can reect the excessive state (when the output
power that you set exceeds what the laser is capable of
producing).
Bit 9, which can reect the initializing state (the instrument is
performing its power-up initialization).
Example OUTPUT 724;":STAT:OPER:PTR 768"
OUTPUT 724;":STAT:OPER:COND?"
ENTER 724;A$
Remote Commands 5-31