117
Chapter 6, Call Processing Subsystem
Using the Call Processing Subsystem
Generalized Procedures Using the Call Processing Subsystem
For general procedures for using the Call Processing Subsystem, see the following
sections:
• "Conditioning the Test Set for Call Processing" on page 130
• "Configure the Test Set" on page 131
• "Turn On The Test Set’s Control Channel" on page 132
• "Register a Mobile Station" on page 132
• "Page a Mobile Station" on page 133
• "Handoff a Mobile Station to a New Voice Channel" on page 135
• "Release A Mobile Station" on page 135
• "Change the Transmit Power Level of a Mobile Station" on page 136
• "Originate a Call from a Mobile Station" on page 137
• "Send an Alert Order to a Mobile Station" on page 138
• "Changing the Content of a Message Field" on page 190
• "Selecting The Message Content Generation Method" on page 187
• "To Make an RF Sensitivity Measurement" on page 196
• "To Make an FM Hum and Noise Measurement" on page 197
To Next Page
