HP 8921A - To Change the Measurement’s Unit-Of-Measure

61
Chapter 3, Operating Overview
Displaying Measurements
To Change the Measurement’s Unit-of-Measure
1. Position the cursor in front of the present unit-of-measurement.
2. Press the key labeled with the desired unit.
All measurements allow you to change the associated unit-of- measure. For
instance; the TX Power measurement is usually displayed in Watts, but can be
changed to display in mW, dBm, V, mV, or dB
µV.
Select mW by pressing SHIFT, ENTER.
For example; to display transmitter power in units of dBm instead of Watts:
1. Move the cursor in front of the unit-of-measure for the TX Power measurement (W).
2. Press the dBm key. The measurement value is changed immediately to display in dBm.