212
Chapter 7, Configure Screen
Field Descriptions
RF Offset
This field is displayed when the RF Display field has Freq selected.
This field enables/disables the RF Generator
−RF Analyzer frequency offset
specified in the (Gen)-(Anl) field below it.
Operating Considerations
When an RF offset is used, changing the RF Generator’s frequency or RF
Analyzer’s tune frequency automatically alters the other setting. On screens
where both fields are not shown (such as the RX TEST and TX TEST screens),
you will not see the corresponding field change.
See Also
"Setting an RF Generator/Analyzer Offset" on page 79
To Next Page
