142
Chapter 6, Call Processing Subsystem
CALL DATA Screen
Display Word
This field is used to select the desired reverse control channel or reverse voice
channel message to be viewed.
Handoff
Order
This field is used to send an order on the forward voice channel to the mobile
station. The orders available are:
• Change Power to Power Level 0 - 7
Maintenance (puts the mobile station in maintenance mode)
• Alert (alerts the mobile station)
The Order field is a one-of-many selection field. To send an order to the mobile
station select the Order field. A list of choices is displayed. Select the desired
order from the Choices: menu. Once the selection is made, a mobile station
control message is sent to the mobile station. The Access annunciator will light
momentarily while the Test Set is sending the mobile station control message.
NOTE: A mobile station must be actively connected on a voice channel to the Test Set (that
is, the
Connect annunciator must be lit) before you can attempt to send an order to a
mobile station.
Page
This field is used to initiate a page to the mobile station connected to the Test Set.
The Test Set must be in the active state (that is, the Active annunciator must be
lit) and the MS Id information field on the CALL CONTROL screen must be
correct before you can attempt to page a mobile station.
[] Page
When lit, the Page annunciator indicates that the mobile station connected to the
Test Set is currently being paged on the forward control channel.
To Next Page
Loading...
