141
Chapter 6, Call Processing Subsystem
CALL DATA Screen
[] Access
When lit, the Access annunciator indicates the Test Set is signaling the mobile
station with command information on the forward voice channel. This is a
transitory state.
The Test Set’s speaker is turned off when in the access state. This is done to
eliminate any possible audio feedback which may occur if the mobile station’s
microphone is open.
Active
This field is used to turn on the forward control channel of the Test Set or to force
a return to the active state from any other state (register, page, access, connect). If
the forward control channel of the Test Set is already active, selecting this field
will deactivate and then reactivate the control channel.
[] Active
When lit, the Active annunciator indicates that the control channel of the Test
Set is turned on. If this annunciator is lit, the base station is transmitting system
parameter overhead messages on the assigned control channel. If the annunciator
is not lit the base station is not active.
NOTE: The Test Set may still be outputting a modulated RF carrier but the Test Set’s firmware is not
active and no communication can occur between a mobile station and the Test Set.
[] Connect
When lit, the Connect annunciator indicates the mobile station is connected to
the Test Set on a voice channel.
To Next Page
Loading...
