Mounting the Hub in a Rack or Cabinet
Note that the rack or cabinet should be adequately secured to prevent it
from falling over.
1. Using a Phillips (cross-head) screwdriver, attach the mounting brackets
to the hub with the 10-mm M4 screws included in the Accessory Kit.
The top of each bracket should align with the top of the hub.
Be careful not to overtighten the screws.
Note that several different rack mount positions are possible by
using the different holes in the bracket and the hub. The illustration
shows the recommended position for a rack mounting; it provides
the most well balanced position for the hub.
align top of bracket
with top of hub
10-mm M4
screws
Installing the
HP AdvanceStack Hubs
Installing the HP AdvanceStack 10Base-T Hubs
1-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
