HP Router Module
The HP J2628A Router 210 Module is an auxiliary module for the
HP AdvanceStack 10Base-T Hub. The Router 210 Module attaches to the
HP J2603B Ethernet SNMP Module and is then installed in the hub’s
expansion slot.
The router module includes two ports:
An external synchronous WAN port supporting RS-232/V.24/V.28,
V.35, X.21, or RS-422/RS-449/V.36 interfaces at speeds of 9.6 Kbit/s to
2.048 Mbit/s. This port allows HP Point-to-Point, PPP, V.25 bis
(dial-up/ISDN), SMDS, frame relay, and LAPB (X.25) connections to
other routers, over point-to-point or switched circuits
An internal Ethernet/802.3 LAN port, through which the router
module communicates with the hub
The router provides both bridging and routing capabilities and supports
the following routing services:
Internet Protocol (TCP/IP protocol suite)
DECnet Phase IV
Xerox XNS
Novell IPX
Reset
button
Clear
button
Battery (maintains
the configuration in
RAM when the hub
is powered off)
WAN port
connector
SNMP module
connector
(internal
LAN port)
Hub Reference
Hub Reference
3-15
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
