Computer Requirements
The HP Stack Manager software runs on IBM-compatible personal
computers with the following minimum configuration:
Microsoft Windows version 3.1 (or later)
80386 (or higher) processor
4 Mbytes of RAM
2 Mbytes of available hard disk space
a 3-1/2" 1.44 Mbyte floppy disk drive
an available RS-232 (serial) port or modem
a VGA monitor
You will also need the following equipment to connect the PC to the hub:
a serial cable (included with hub) to connect the PC directly to the
hub, or two modems (if connecting through a modem link) and a
standard modem cable to connect the modem to the hub. The cable
included with the hub will not work as a modem cable.
See appendix A, “Cables and Connectors” for details on appropriate
cables. Connecting the hub and the PC (or modem) is described in
detail in chapter 1, “Installing the HP AdvanceStack 10Base-T Hubs”.
10Base-T twisted-pair cables (if you have multiple hubs that you are
chaining together).
Installing and Using
HP Stack Manager
Installing and Using HP Stack Manager
2-3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
