9. Remove the tape from the touch cable connector (5), and then disconnect the touch cable from the
system board (6).
Reverse this procedure to reassemble and replace the display panel.
Battery
To remove the battery, use this procedure and illustration.
Table 6-2
Battery description and part number
Description Spare part number
Battery (2 cell, 47 Wh) M51660-001
WARNING! To avoid personal injury and damage to the product:
● Do not puncture, twist, or crack the battery.
● Do not cause an external puncture or rupture to the battery. They can cause a short inside the battery,
which can result in battery thermal runaway.
46
Chapter 6 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
