Front bezel security
The front bezel can be locked in place by installing a security screw provided by HP. To install the
security screw:
1. Prepare the computer for disassembly (
Preparation for disassembly on page 141).
2. Remove the access panel (
Access panel on page 142).
3. Remove the front bezel (
Front bezel on page 143).
4. Remove the black screw on the front of the chassis behind the bezel. The screw is located next to
the optical drive and is labeled "BEZEL."
5. Replace the front bezel.
6. Install the security screw through the middle front bezel release tab and into the chassis to secure
the front bezel in place.
144 Chapter 7 Removal and replacement procedures: Ultra-slim Desktop (USDT)
To Next Page
Loading...
