Changing from desktop to tower configuration
The Ultra-slim Desktop can be used in a tower orientation with the tower stand included with the
computer.
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as compact discs or USB flash drives, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION: Regardless of the power-on state, voltage is always present on the system board as
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5. Orient the computer so that its left side is facing down and place the computer firmly down into
the stand.
6. Reconnect the external equipment, plug the power cord into a power outlet, and turn the computer
on.
NOTE: Ensure at least 10.2 centimeters (4 inches) of space on all sides of the computer remains
clear and free of obstructions.
NOTE: An optional Quick Release mounting bracket is available from HP for mounting the computer
to a wall, desk, or swing arm. When the mounting bracket is used, do not install the computer with the
I/O ports oriented towards the ground.
178 Chapter 7 Removal and replacement procedures: Ultra-slim Desktop (USDT)
To Next Page
Loading...
Need help?
General