HP EliteDesk 800 G1 Small Form Factor Service Manual

4. Release the drive by pulling the release tab away from the drive (1) and sliding the drive out of the
bay (2).
5. Remove the four guide screws (two on each side) from the old drive. You will need these screws to
install a new drive.
Installing a 3.5-inch or 2.5-inch hard drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 44)
2. Remove the access panel (
Access panel on page 45)
Drives
71

HP EliteDesk 800 G1 Small Form Factor Specifications

General

Brand	HP
Model	EliteDesk 800 G1 Small Form Factor
Category	Desktop
Language	English