9
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Table 4 Command output
Field Description
Current state
State of the Ethernet interface:
• Administratively DOWN—The Ethernet interface was shut
down with the shutdown command. The interface is
administratively down.
• DOWN—The Ethernet interface is administratively up but
physically down (possibly because no physical link is
present or the link has failed).
• UP—The Ethernet interface is both administratively and
physically up.
Line protocol state
Link layer state of the interface. The state is determined through
parameter negotiation on the link layer.
• UP—The interface is up at the data link layer.
• UP (spoofing)—The link layer protocol of an interface is UP,
but its link is an on-demand link or not present at all. This
attribute is typical of Null interfaces and loopback interfaces.
• DOWN—The interface is down at the data link layer.
• DOWN (DLDP DOWN)—The link layer protocol of the
interface is down because DLDP detected that the link was
unidirectional.
• DOWN (LAGG DOWN)—The link layer protocol of the
interface is down because the aggregate interface does not
have Selected ports.
• DOWN (OAM DOWN)—The link layer of the interface is
down because OAM detected remote link failures.
• DOWN (DLDP and LAGG DOWN)—The link layer of the
interface is shut down by DLDP and LAGG.
• DOWN (DLDP and OAM DOWN)—The link layer of the
interface is shut down by DLDP and OAM.
• DOWN (OAM and LAGG DOWN)—The link layer of the
interface is shut down by OAM and LAGG.
• DOWN (DLDP, OAM and LAGG DOWN)—The link layer of
the interface is shut down by DLDP, OAM, and LAGG.
IP packet frame type
Ethernet framing format.
PKTFMT_ETHNT_2
indicates that the
frames are encapsulated in Ethernet II framing format.
hardware address MAC address of the interface.
Bandwidth Expected bandwidth of the interface.
Loopback is set internal An internal loopback test is running on the Ethernet interface.
Loopback is set external An external loopback test is running on the Ethernet interface.
Loopback is not set No loopback test is running on the Ethernet interface.
10Mbps-speed mode The interface is operating at 10 Mbps.
100Mbps-speed mode The interface is operating at 100 Mbps.
1000Mbps-speed mode The interface is operating at 1000 Mbps.
10Gbps-speed mode The interface is operating at 10 Gbps.
Unknown-speed mode
The speed of the interface is unknown because the speed
negotiation fails or the interface is physically disconnected.
To Next Page
Loading...
Need help?
General