10
Field Description
half-duplex mode The interface is operating in half duplex mode.
full-duplex mode The interface is operating in full duplex mode.
unknown-duplex mode
The duplex mode of the interface is unknown because the duplex
mode negotiation fails or the interface is physically disconnected.
Link speed type is autonegotiation The interface is configured with the
speed auto
command.
Link speed type is force link
The interface is configured with a speed by using the
speed
command.
link duplex type is autonegotiation The interface is configured with the
duplex auto
command.
link duplex type is force link
The interface is configured with a duplex mode by using the
duplex
command.
Maximum frame length Maximum Ethernet frame length allowed on the interface.
Allow jumbo frames to pass The interface allows jumbo frames to pass through.
Broadcast max-
Broadcast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Multicast MAX-
Multicast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
Unicast max-
Unicast storm suppression threshold in ratio, pps, or kbps. The
unit of the threshold depends on your configuration.
PVID Port VLAN ID (PVID) of the Ethernet interface.
MDI type
Cable type (depending on your configuration):
• automdix.
• mdi.
• mdix.
Port link-type
Link type of the interface (depending on your configuration):
• access.
• trunk.
• hybrid.
Tagged VLANs
VLANs for which the interface sends packets without removing
VLAN tags.
UnTagged VLANs
VLANs for which the interface sends packets after removing
VLAN tags.
Port priority Priority of the interface.
Last link flapping
Duration since the most recent physical state change of the
interface.
Never
indicates that the interface state has never
changed.
Last clearing of counters: Never
Time when the
reset counters interface
command was last
used to clear statistics on the interface.
Never
indicates that the
reset counters interface
command was never used since the
device was started.
Peak input rate
Peak rate of inbound traffic in Bps, and the time when the peak
inbound traffic rate occurred.
Peak output rate
Peak rate of outbound traffic in Bps, and the time when the peak
outbound traffic rate occurred.
Last 300 second input
Average rate of inbound traffic in the last 300 seconds, in pps and
Bps, and the ratio of the actual rate to the maximum interface
To Next Page
Loading...
Need help?
General