Chapter 4
Utilities
Specifying SCSI Parameters
50
Step 4. Using the information (the driver’s handle [Drv] and the controller’s handle [Ctrl]) from the
drvcfg command, start the EFI SCSI Setup Utility for one channel of this SCSI interface. Still at
the EFI shell prompt, type this command:
drvcfg -s
drvr_handle cntrl_handle
where
•
drvr_handle
is the handle of the driver that controls the channel whose SCSI ID you want to
display or change
•
cntrl_handle
is the handle of the controller for the channel whose SCSI ID you want to
display or change
So, continuing the example for channel A of this SCSI interface, you would type:
drvcfg -s 45 18
Step 5. The EFI SCSI Setup Utility starts and its main menu is displayed, showing a list of all the EFI
capable SCSI interfaces in the system.
To Next Page
Loading...
Need help?
General