Chapter 3
Removing and Replacing Components
Removing and Replacing the Bulk Power Supply (BPS)
90
Removing and Replacing the Bulk Power Supply (BPS)
The Bulk Power Supply (BPS) is located in the front end power system (FEPS). The BPS is an N+1 component
and is easily replaced.
Removing the Bulk Power Supply
This section contains information on removing a BPS.
Figure 3-6 BPS detail
Step 1. Loosen the single captive thumbscrew in the lower front center portion of the BPS.
Step 2. Slide the power supply forward using the handle to remove it from the FEPS.
Step 3. Make note that the BPS is defective for future reference.
To Next Page
Loading...
